Here is how to reset MX330 Ink Cartridge (210 model) Counter in Win Vista System:
1. Refill cartridge and install back to printer.
2. Open Properties in "Printers" from "Start Bar"-"Settings" on left lower corner.
3. Open "Advance".
4. Uncheck "Enable advanced printing features".
5. Apply and close.
6. Hold "Stop" button on MX330 printer for 10-20 seconds. The "Run out of ink" message will disappear.
7. Open "Properties" in "Printers" again as in Step 2.
8. Check "Enable advance printing features" to reset counter.
9. Printer should work again with refilled ink cartridge. (Unquote)
Method 2 – (Quoted)
Tried refilling the cartridges PG210 & CL211 inside my Canon MX 320, it goes well for 2 refills,
however on the third time after I refilled, an error code 'U051' appeared on the little LED screen says
'Check ink U051 clo blk'. The printer worked the first two times by pushing down on the stop/reset button for 5 seconds but not this time. I tried another pair of cartridges from another printer (MP240) which have been refilled a few times and still working, the same problem showed up. Does this mean I have to buy a pair of brand new OEM Canon cartridges after 2 refills on this particular model? I tried putting the printer into service mode and tried the resetting counter method etc. and none help. Anyone any suggestions?
Sorry to hear you’re not getting any help on here. So try this, buy a new set of canon cartridges and when they run out put back in your current set which should work again. You need to rotate your cartridges and not keep putting back in the same ones all the time. That way you will always have a spare set on hand..
Assuming that your printer (ip4600 series) is already installed on your PC.
Reset can be done once your printer is on Service Mode:
a. Switch Off the Printer
b. Hold the Resume Button
c. Switch On and Hold the Power Button
d. Release the Resume Button
e. Press the Resume Button Twice
f. Release the Power Button
By this time your printer is in service mode already. Run the Service Tool Program (Resetter) Select ASA as the Region (for ASIA PACIFIC - depends on your location) (Unquote)
Method 3 – (Quoted)
Someone post this for Canon mx 300 (its supposed to works for the mx328 too) :
1- Switch off the Canon MX300 and disconnect the power cable.
2- While press and hold the power button, Connect the power cable to electric socket.
3- While pressing the power button, press the “Cancel/Stop” button (red button). (press TWICE che “stop\cancel” button)
4- Now release the power button and the printer turns into a kind of factory mode. Wait for 10 seconds until it says “idle”.
5- Press “>” (next button) once “Shipping Mode 3? then Press the “OK” button. Press “OK” again for “without cleaning”. A test page will print.
6- Open the cover, like you are about to change the cartridges.
7- Disconnect the power cable again without switch off the printer.
8- Take out the both cartridges.
9- Close the cover.
10- Connect the power cable and turn on the printer.
11- Now just put the cartridges back and the ink level in the canon Pixma MX300 have full again. (Unquote).
No comments:
Post a Comment