how to solve Canon Printer error code E08

This error appears with this message: “The Ink Absorber is Almost Full”
To solve this problem, you have to reset the waste ink counter.

Call Canon Help Center +1-800-577-1869

Solution:

• Turn on the printer.
• The panel will display error E08, with message “The Ink Absorber is Almost Full”. 
• Download the Resetter for MP287 
• Printer must be in a state of Service Mode. 
• Turn off the E08 error by pressing the power button. 
• Do not unplug the power cord. 
• Press and Hold the button Stop/Reset followed by pressing the Power button. 
• Release the button Stop/Reset only.
• Press the button Stop/Reset 6 times, then release both buttons simultaneously.
• The printer MP287 will be in Service Mode. 
• LCD Panel will blank / dark and in your computer will detect new hardware. Ignore it. 
• Exctract and Run Service Tool for MP287 
• Click on “Play”, then the printer will proceed and will print one page with the words “D = 000.0″ 
• Click “Clear EEPROM”. Then click “EEPROM”, and the printer will print the results Resetter. Writing one line as follows: “TPage (COPY TTL = 00 000 = 00 000)”. 
• Turn off by pressing the power.

Call Canon Help Center +1-800-577-1869

•  

How to fix error 6C10 on Canon Printers

This error appears on these printers: MP110, MP540, MP630, MP620, MP640, IP3600... and others...
Solution 1:

• Move the printhead to the center.
• Disconnect the printer and check on the right: is the purge unit ok ? No peace of paper ?

Solution 2:

• Do a reset of the printer:
• Power on
• Hold down the "Resume" button (triangle in a circle)  for 15 to 20 seconds.

Solution 3:

• Power off the printer.
• Open the door.
• Power on.
• When the cartridge is in the center, close the door.

Solution 4:

• Open the lid and allow the ink cartridge carrier to center itself. 
• Looking to the right, you will see a row of white rollers behind the carrier. 
• At the end of the rollers there is a small, clear piece of plastic that sticks up. Take a small piece of a paper towel and wipe all of the ink off this piece of plastic. When that is clean move on to the ink pad.
• About 1 inch, towards the front of the printer from that piece of plastic, is a small square, about 1/2 inch per side, that is a small foam pad. This is where the excess ink is collected. 
• Take a piece of paper towel and press into the foam. Do this until the paper towel is no longer collecting ink. Close the lid, turn off the printer then turn it back on.

·         Post a Question....